Rohde & Schwarz MXO 4 Series - Page 102

Instrument setupMXO 4 Series
102User Manual 1335.5337.02 ─ 07
File name
If enabled, inserts the default file name. The file name indicates the type of data that is
saved, for example, RefCurve, Settings.
Remote command:
MMEMory:AUTonaming:PREFix on page 501
Date/time
If enabled, the current date and time are inserted in the filename pattern.
Remote command:
MMEMory:AUTonaming:TIME on page 501
Index
If enabled, inserts an index.
Remote command:
MMEMory:AUTonaming:INDex on page 501
Enable autosave
Enables the automatic saving of the waveform. With "Autosave interval", you can
define the time interval for the automatic saving.
Remote command:
MMEMory:AUSave:ENABle on page 501
MMEMory:AUSave:INTerval on page 501
Default path for all file operations
Defines the path that is displayed in the file selection dialog box for loading and storing
operations. On the instrument, all user data is written to /home/storage/userData.
You can create subfolders in this folder. The path to a USB storage device
is /run/media/usb/.
To switch the directory quickly, double-tap the path button. Use the symbols on the left
of the file explorer box to change the directory.
Remote command:
MMEMory:AUTonaming:DEFaultpath on page 502
Reset path
Resets the default file path to the factory default.
Remote command:
MMEMory:AUTonaming:RESPath on page 502
MMEMory:AUTonaming:RESall on page 502
5.8.1.2 Defining default file paths and names
When a save or load operation is performed, a default file name and path is provided.
You can configure which path is used and how the file name is generated. In the file
selection dialog box, you can change the folder and name as desired.
Save / recall