Rohde & Schwarz MXO 4 Series - Page 133

Acquisition and waveform setupMXO 4 Series
133User Manual 1335.5337.02 ─ 07
Figure 6-5: Probe setup for power rail probe R&S RT ‑ ZPR20
Most settings are common settings, which are available for all probe types. See Chap-
ter 6.4.1, "Common probe settings", on page 125 for description of these settings.
The "Offset" is the channel offset, see "Offset" on page 121.
Specific settings for R&S RT‑ZPR probe are the following:
AC Coupling
Enables AC coupling in R&S RT‑ZPR power rail probes, which removes DC and very
low-frequency components. The R&S RT‑ZPR probe requires 50 Ω input termination,
for which the channel AC coupling is not available. The probe setting allows AC cou-
pling also at 50 Ω inputs.
Remote command:
PROBe<ch>:SETup:ACCoupling on page 526
Probes