Acquisition and waveform setupMXO 4 Series
134User Manual 1335.5337.02 ─ 07
ProbeMeter to offset
Sets the measured ProbeMeter value as offset. Thus, the value is considered in mea-
surements.
Remote command:
PROBe<ch>:SETup:ADVanced:PMToffset on page 531
6.4.3.4 Setup for R&S RT-ZHD high-voltage differential probes
R&S RT-ZHD high-voltage differential probes are designed to measure safely high-volt-
age floating circuits using a grounded oscilloscope. They extend the measurement
capability of oscilloscopes to measure electronic power converters, inverters, motor
speed controls, switch mode power supplies and many other applications.
Figure 6-6: Setup for high-voltage differential probe R&S
RT-ZHD07
Most settings are common settings, which are available for all probe types. See Chap-
ter 6.4.1, "Common probe settings", on page 125 for description of these settings.
Probes
To Next Page
Loading...
