TriggerMXO 4 Series
153User Manual 1335.5337.02 ─ 07
ger can detect logic, digital, and analog signals remaining below a specified threshold
amplitude because I/O ports are in undefined state.
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Polarity
Sets the polarity of a pulse, which is the direction of the first pulse slope.
"Positive"
Selects positive going pulses, the width is defined from the rising to
the falling slopes.
"Negative"
Selects negative going pulses, the width is defined from the falling to
the rising slopes.
"Either"
Selects both positive and negative going pulses.
Remote command:
TRIGger:EVENt<ev>:GLITch:POLarity on page 547
TRIGger:EVENt<ev>:RUNT:POLarity on page 550
Upper level
Sets the upper voltage limit.
Trigger types
To Next Page
Loading...
