Rohde & Schwarz MXO 4 Series - Page 496

Remote control commandsMXO 4 Series
496User Manual 1335.5337.02 ─ 07
Parameters:
<ShowLabels> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Show labels" on page 86
DISPlay:DIAGram:XFIXed <XGridFixed>
If enabled, the vertical grid lines remain in their position when the horizontal position is
changed. Only the values at the grid lines are adapted.
Parameters:
<XGridFixed> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Keep X-grid fixed" on page 87
DISPlay:DIAGram:YFIXed <YGridFixed>
If enabled, the horizontal grid lines remain in their position when the position of the
curve is changed. Only the values at the grid lines are adapted.
Fixed horizontal grid lines correspond to the behavior of traditional oscilloscopes.
Parameters:
<YGridFixed> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Keep Y-grid fixed" on page 87
17.7.4.3 Dialog appearance
DISPlay:DIALog:FONTsize..............................................................................................496
DISPlay:DIALog:TRANsparency......................................................................................497
DISPlay:RESult:FONTsize.............................................................................................. 497
DISPlay:DIALog:FONTsize <DialogFontSize>
Sets the font size of the text in dialog boxes.
Parameters:
<DialogFontSize> Range: 12 to 30
Increment: 1
*RST: 19
Usage: Asynchronous command
Manual operation: See "Font size (Dialog)" on page 87
Instrument setup