Rohde & Schwarz MXO 4 Series - Page 495

Remote control commandsMXO 4 Series
495User Manual 1335.5337.02 ─ 07
17.7.4.2 Grid appearance
DISPlay:DIAGram:CROSshair.........................................................................................495
DISPlay:DIAGram:FINegrid.............................................................................................495
DISPlay:DIAGram:GRID................................................................................................. 495
DISPlay:DIAGram:LABels...............................................................................................495
DISPlay:DIAGram:XFIXed.............................................................................................. 496
DISPlay:DIAGram:YFIXed.............................................................................................. 496
DISPlay:DIAGram:CROSshair <Crosshair>
If selected, a crosshair is displayed in the diagram area. A crosshair allows you to
select a specific data point by its coordinates.
Parameters:
<Crosshair> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Show crosshair" on page 86
DISPlay:DIAGram:FINegrid <ShowFineScale>
If selected, the crosshair is displayed as a ruler with scale markers. If disabled, the
crosshair is shown as dashed lines.
Parameters:
<ShowFineScale> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Show fine grid scale" on page 86
DISPlay:DIAGram:GRID <Show>
If selected, a grid is displayed in the diagram area. A grid helps you associate a spe-
cific data point to its exact value on the x- or y-axis.
Parameters:
<Show> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Show grid" on page 86
DISPlay:DIAGram:LABels <ShowLabels>
If selected, labels mark values on the x- and y-axes in specified intervals in the dia-
gram.
Instrument setup