Rohde & Schwarz MXO 4 Series - Page 534

Remote control commandsMXO 4 Series
534User Manual 1335.5337.02 ─ 07
Parameters:
<VoltageAdj> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Asynchronous command
PROBe<ch>:SETup:TERM:MEASure?
Returns the measured common mode voltage.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Return values:
<VoltageMeas> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Query only
Asynchronous command
PROBe<ch>:SETup:TERM:MODE <Mode>
Selects the voltage that is used for termination.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<Mode> AUTO | MANual
AUTO: the instrument uses the measured common mode volt-
age for termination.
MANual: enter the voltage to be used for termination with
PROBe<ch>:SETup:TERM:ADJust.
*RST: AUTO
Usage: Asynchronous command
PROBe<ch>:SETup:TERM:STATe <VoltageState>
Activates control of the termination voltage.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<VoltageState> ON | OFF
*RST: OFF
Usage: Asynchronous command
Acquisition and setup