Rohde & Schwarz MXO 4 Series - Page 533

Remote control commandsMXO 4 Series
533User Manual 1335.5337.02 ─ 07
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<DMOffset> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Asynchronous command
PROBe<ch>:SETup:NOFFset <NOffset>
Sets the negative offset to compensate a DC voltage applied to the negative input ter-
minal (V
n
) referenced to ground.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<NOffset> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Asynchronous command
PROBe<ch>:SETup:POFFset <POffset>
Sets the positive offset to compensate a DC voltage applied to the positive input termi-
nal (V
p
) referenced to ground.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<POffset> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Asynchronous command
PROBe<ch>:SETup:TERM:ADJust <VoltageAdj>
Activates control of the termination voltage.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Acquisition and setup