Rohde & Schwarz MXO 4 Series - Page 620

Remote control commandsMXO 4 Series
620User Manual 1335.5337.02 ─ 07
MEASurement<mg>:RESult:EVTCount?.......................................................................... 620
MEASurement<mg>:RESult:STDDev?.............................................................................620
MEASurement<mg>:RESult:STARt?................................................................................620
MEASurement<mg>:RESult:STOP?................................................................................ 620
MEASurement<mg>:RESult:EVENts:COUNt?...................................................................621
MEASurement<mg>:RESult:EVENts:STARt?....................................................................621
MEASurement<mg>:RESult:EVENts:STOP?.................................................................... 621
MEASurement<mg>:RESult:EVENts:VALue?................................................................... 622
MEASurement<mg>:RESult[:ACTual]?
MEASurement<mg>:RESult:AVG?
MEASurement<mg>:RESult:NPEak?
MEASurement<mg>:RESult:PPEak?
MEASurement<mg>:RESult:RELiability? [<MeasType>]
MEASurement<mg>:RESult:RMS?
MEASurement<mg>:RESult:WFMCount?
MEASurement<mg>:RESult:EVTCount?
MEASurement<mg>:RESult:STDDev?
Return the statistic results of the specified measurement. If no parameter is specified,
the result of the main measurement is returned. The main measurement is defined
using MEASurement<mg>:MAIN.
●
[:ACTual]: current measurement result
●
AVG: average of the measurement results
●
EVTCount: number of measurement results in the measurement
●
NPEak: negative peak value of the measurement results
●
PPEak: positive peak value of the measurement results
●
RELiability: reliability of the measurement result
●
RMS: RMS value of the measurement results
●
STDDev: standard deviation of the measurement results
Suffix:
<mg>
.
1...16, index of the measurement
Return values:
<StdDev> Range: -1E+26 to 1E+26
Increment: 1E-10
*RST: 0
Usage: Query only
Asynchronous command
MEASurement<mg>:RESult:STARt?
MEASurement<mg>:RESult:STOP?
Return the start and stop times of the specified measurement. The parameter defines
the measurement. If no parameter is specified, the result of the main measurement is
returned. The main measurement is defined using MEASurement<mg>:MAIN.
Automatic measurements