Rohde & Schwarz MXO 4 Series - Page 636

Remote control commandsMXO 4 Series
636User Manual 1335.5337.02 ─ 07
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | SBUS1 | SBUS2 | SBUS3 |
SBUS4 | M1 | M2 | M3 | M4 | M5 | SPECMAXH1 | SPECMINH1 |
SPECNORM1 | SPECAVER1
Usage: Asynchronous command
Manual operation: See "Source" on page 212
CURSor<cu>:USSource <UseSource2>
Enables the second cursor source. To select the second source, use CURSor<cu>:
SSOurce.
If enabled, the second cursor lines Cx.2 measure on the second source. Using a sec-
ond source, you can measure differences between two channels with cursors.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<UseSource2> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Second source, Source 2" on page 212
CURSor<cu>:SSOurce <Source2>
Selects the second cursor source.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<Source2> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | SBUS1 | SBUS2 | SBUS3 |
SBUS4 | M1 | M2 | M3 | M4 | M5 | SPECMAXH1 | SPECMINH1 |
SPECNORM1 | SPECAVER1
Second source of the cursor measurement.
Usage: Asynchronous command
Manual operation: See "Second source, Source 2" on page 212
CURSor<cu>:X1Position <X1Position>
Defines the position of the left vertical cursor line.
Suffix:
<cu>
.
1...2, index of the cursor set
Cursor measurements