Rohde & Schwarz MXO 4 Series - Page 637

Remote control commandsMXO 4 Series
637User Manual 1335.5337.02 ─ 07
Parameters:
<X1Position> Range: 0 to 500
Increment: 0.1
*RST: depends on time scale, at 25% of the time axis
Default unit: s
Usage: Asynchronous command
Manual operation: See "X1 position, X2 position" on page 213
CURSor<cu>:X2Position <X2Position>
Defines the position of the right vertical cursor line.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<X2Position> Range: 0 to 500
Increment: 0.1
*RST: depends on time scale, at 75% of the time axis
Default unit: s
Usage: Asynchronous command
Manual operation: See "X1 position, X2 position" on page 213
CURSor<cu>:Y1Position <YPosition1>
Defines the position of the lower horizontal cursor line.
If CURSor<cu>:TRACking[:STATe] is enabled, the y-positions are set automatically.
The query returns the measurement result - the lower vertical value of the waveform.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<YPosition1> Range: -50 to 50
Increment: 0.01
*RST: 0
Usage: Asynchronous command
Manual operation: See "Y1 position, Y2 position" on page 213
CURSor<cu>:Y2Position <YPosition2>
Defines the position of the upper horizontal cursor line.
If CURSor<cu>:TRACking[:STATe] is enabled, the y-positions are set automatically.
The query returns the measurement result - the upper vertical value of the waveform.
Suffix:
<cu>
.
1...2, index of the cursor set
Cursor measurements