Rohde & Schwarz MXO 4 Series - Page 728

Remote control commandsMXO 4 Series
728User Manual 1335.5337.02 ─ 07
Parameters:
<sda position>
Usage: Asynchronous command
SBUS<sb>:I2C:SDA:SCALe <sda scale>
Set the vertical scale of the SDA I2C signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<sda scale>
Usage: Asynchronous command
SBUS<sb>:I2C:POSition <Position>
Sets the vertical position of the I
2
C signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Position>
Usage: Asynchronous command
SBUS<sb>:I2C:SCALe <Scale>
Set the vertical scale of the I
2
C signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Scale>
Usage: Asynchronous command
SBUS<sb>:I2C:SYMBols <ShowSymbols>
Activates the symbol list to be used for decoding.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<ShowSymbols> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show symbols" on page 340
Protocols