Protocol analysisMXO 4 Series
340User Manual 1335.5337.02 ─ 07
Show threshold lines
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Remote command:
SBUS<m>:THReshold on page 705
13.3.2.3 Display settings
For details about the display settings, see Chapter 13.1.4, "Display", on page 315.
Show symbols
Symbol lists are protocol-specific. Label lists for I2C are available in CSV format.
For details, see I
2
C symbols.
Remote command:
SBUS<sb>:I2C:SYMBols on page 728
SBUS<sb>:I2C:NEWList on page 729
I²C (option R&S
MXO4-K510)
To Next Page
Loading...
