Rohde & Schwarz MXO 4 Series - Page 734

Remote control commandsMXO 4 Series
734User Manual 1335.5337.02 ─ 07
SBUS<sb>:I2C:FILTer:CLR
Disables the filter for all available frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 342
SBUS<sb>:I2C:FILTer:INVert
Inverts the current state of the frame and error types: all frames and error types that
were enabled are disabled and vice versa.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 342
SBUS<sb>:I2C:FILTer:RST
Resets the state of the selected frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 342
SBUS<sb>:I2C:FILTer:ENABle <Enable>
Enables the filtering on I2C frames. Only the frames that match the selected filter con-
ditions are displayed.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Enable> ON | OFF
*RST: ON
Usage: Asynchronous command
Protocols