Rohde & Schwarz RTE Series - Page 1124

Remote control commands
R&S
®
RTE
1124User Manual 1326.1032.02 ─ 20
PROBe<m>:SETup:ATTenuation[:AUTO]?...................................................................... 1125
PROBe<m>:SETup:OFFSet:AZERo...............................................................................1125
PROBe<m>:SETup:OFFSet:USEautozero......................................................................1125
CHANnel<m>:EATScale............................................................................................... 1126
CHANnel<m>:EATTenuation..........................................................................................1126
TRPRobe:SETup:STATe?
PROBe<m>:SETup:STATe?
Queries if the probe at the specified input channel is active (detected) or not active (not
detected). To switch the probe on, use CHANnel<m>:STATe.
Suffix:
<m>
.
1..4
Return values:
<State> DETected | NDETected
*RST: NDETected
Usage: Query only
Asynchronous command
TRPRobe:SETup:TYPE?
PROBe<m>:SETup:TYPE?
Queries the type of the probe.
Suffix:
<m>
.
1..4
Selects the input channel.
Return values:
<Type> String containing one of the following values:
– None (no probe detected)
– Passive Probe
– active single-ended
Usage: Query only
Asynchronous command
TRPRobe:SETup:NAME?
PROBe<m>:SETup:NAME?
Queries the name of the probe.
Suffix:
<m>
.
1..4
Selects the input channel.
Return values:
<Name> Name string
Usage: Query only
Asynchronous command
Acquisition and setup