Rohde & Schwarz RTE Series - Page 1413

Remote control commands
R&S
®
RTE
1413User Manual 1326.1032.02 ─ 20
Suffix:
<1..2>
.
Selects the output configuration.
Parameters:
<Medium> MMEM | SYST:COMM:CLIP | SYST:COMM:PRIN
String parameter
MMEM
Directs the display image to a file. The MMEMory:NAME com-
mand defines the file name. The file format is defined with
HCOPy:DEVice<m>:LANGuage.
SYST:COMM:CLIP
Directs the hardcopy to the clipboard.
SYST:COMM:PRIN
Directs the display image to the printer. The printer is selected
with the SYSTem:COMMunicate:PRINter:SELect<1..2>
command. The HCOPy:DESTination command should always
be sent after setting the printer.
*RST:
SYST:COMM:CLIP
Example:
HCOP:DEST 'MMEM'
See also Chapter 18.3.5.1, "Saving a screenshot to file",
on page 1061
MMEMory:NAME <FileName>
Defines the file name when an image of the display is stored to a file.
Setting parameters:
<FileName> String parameter specifiying path and file name of the screen-
shot.
Example: See Chapter 18.3.5.1, "Saving a screenshot to file",
on page 1061
Usage: Setting only
SCPI confirmed
HCOPy:DEVice<m>:LANGuage <FileFormat>
Defines the file format for output of the display image to file.
To set the output to file, use HCOPy:DESTination<1..2> with parameter 'MMEM'.
Suffix:
<m>
.
1..2
Selects the output configuration.
Parameters:
<FileFormat> PNG | JPG | BMP | TIFF | PDF
*RST: PNG
Data management