Rohde & Schwarz RTE Series - Page 1584

Remote control commands
R&S
®
RTE
1584User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:FLXRay:PMAX <SearchName>,<PayloadLengthTo>
SEARch:TRIGger:FLXRay:PMAX? <SearchName>
Sets the the end value of a payload length range if the condition SEARch:TRIGger:
FLXRay:PCONdition is set to INRange or OORange.
Parameters:
<PayloadLengthTo> Range: 0 to 127
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PMIN <SearchName>,<PayloadLength>
SEARch:TRIGger:FLXRay:PMIN? <SearchName>
Specifies a payload length - the number of words in the payload segment - or sets the
the start value of an payload length range. Information is transmitted in 2-byte words,
so the number of data bytes in the payload segment is twice the payload length.
Parameters:
<PayloadLength> Range: 0 to 127
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:STFRame <SearchName>,<StartupFrame>
SEARch:TRIGger:FLXRay:STFRame? <SearchName>
Searches for startup frames used for startup of the network. Only specific start nodes
can send this frame type.
Parameters:
<StartupFrame> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:SYFRame <SearchName>,<SyncFrame>
SEARch:TRIGger:FLXRay:SYFRame? <SearchName>
Searches for the sync frame used for synchronization of the FlexRay system. Only
sync nodes can send this frame type.
Protocols