Rohde & Schwarz RTE Series - Page 1597

Remote control commands
R&S
®
RTE
1597User Manual 1326.1032.02 ─ 20
Parameters:
<ChannelOffset> Range: 0 to 32 (left-justified). TDM: maximum delay is
Channel length - Word length
Increment: 1
*RST: 0
Default unit: bit
BUS<m>:I2S:CHANnel:TDMCount <ChannelsTDM>
Sets the number of channels transmitted on the TDM audio line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ChannelsTDM> Range: 1 to 8
Increment: 1
*RST: 1
BUS<m>:I2S:FOFFset <FrameOffsetTDM>
Sets the number of bits between the frame start and the start of the first channel of a
TDM audio line. Each FSYNC edge restarts the offset count.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<FrameOffsetTDM> Range: 0 to 256
Increment: 1
*RST: 0
Default unit: bit
BUS<m>:I2S:CHANnel:LENGth <ChlgthTDM>
Sets the number of bits in a TDM channel block.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ChlgthTDM> Range: 4 to 32
Increment: 4
*RST: 8
Default unit: bit
Protocols