Remote control commands
R&S
®
RTE
1599User Manual 1326.1032.02 ─ 20
WSELect
WordSELect: Triggers on the selected edge of the WS line (I²S
standard, left- and right-justified). For TDM signals, it triggers on
the selected edge of the FSYNC line. Set the edge with
TRIGger<m>:I2S:WSSLope.
ECONdition
ErrorCONdition: Triggers on irregularities between the WS or
FSYNC edges.
*RST: DATA
Usage: Asynchronous command
TRIGger<m>:I2S:TCONdition<n>:CHANnel
<Channel>
Selects the audio channel on which the instrument looks for the specified data condi-
tion.
Suffix:
<n>
.
1..4
1 if trigger type is DATA or WINDow
Specifies the condition number if trigger type is CONDition:
– 1 | 2 for I²S standard, left- und right-justified data formats
– 1 | 2 | 3 | 4 for TDM signals
Parameters:
<Channel> ANY | TDMC1 | TDMCh1 | TDMC2 | TDMCh2 | TDMC3 |
TDMCh3 | TDMC4 | TDMCh4 | TDMC5 | TDMCh5 | TDMC6 |
TDMCh6 | TDMC7 | TDMCh7 | TDMC8 | TDMCh8 | LEFT |
RIGHT | RIGHt
ANY
The instrument triggers on any channel on which the specified
data is found.
LEFT | RIGHT = RIGHt
Available for I²S Standard, left- und right-justified data formats.
TDMCh1 | TDMCh2 | TDMCh3 | TDMCh4 | TDMCh5 | TDMCh6
| TDMCh7 | TDMCh8
Available for TDM audio signals
TDMC1 = TDMCh1, TDMC2 = TDMCh2, TDMC3 = TDMCh3,
TDMC4 = TDMCh4, TDMC5 = TDMCh5, TDMC6 = TDMCh6,
TDMC7 = TDMCh7, TDMC8 = TDMCh8. Query returns short
form.
Note: Available audio channels depend on the configuration of
the audio bus. The command BUS<m>:I2S:CHANnel:
TDMCount specifies the number of channels in a TDM frame.
*RST:
ANY
TRIGger<m>:I2S:TCONdition<n>:CONDtion <DataCondition>
Sets the operator to set a specific data pattern or a data pattern range.
Protocols
To Next Page
Loading...
