Rohde & Schwarz RTE Series - Page 1602

Remote control commands
R&S
®
RTE
1602User Manual 1326.1032.02 ─ 20
BUS<m>:I2S:FRAMe<n>:RIGHt:STATe?........................................................................1603
BUS<m>:I2S:FRAMe<n>:TDM<o>:STATe?.................................................................... 1603
BUS<m>:I2S:FRAMe<n>:TDM<o>:VALue?.................................................................... 1604
BUS<m>:I2S:FCOunt?
Returns the number of decoded frames.
Suffix:
<m>
.
1..4
Selects the serial bus.
Return values:
<Count> Number of decoded audio frames
Usage: Query only
BUS<m>:I2S:FRAMe<n>:STATe?
Returns the overall state of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<FrameState> ERRor | OK | INSufficient
OK: the frame is valid.
ERRor: an error occured in the frame.
INSufficient: The frame is not completely contained in the acqui-
sition. The acquired part of the frame is valid.
Usage: Query only
BUS<m>:I2S:FRAMe<n>:STARt?
BUS<m>:I2S:FRAMe<n>:STOP?
Return the start time and stop time of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<Start>, <Stop> Range: -100E+24 to 100E+24
*RST: 0
Usage: Query only
Protocols