Rohde & Schwarz RTE Series - Page 1603

Remote control commands
R&S
®
RTE
1603User Manual 1326.1032.02 ─ 20
BUS<m>:I2S:FRAMe<n>:LEFT:VALue?
BUS<m>:I2S:FRAMe<n>:RIGHt:VALue?
Return the data values of the left and right channel, respectively.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<Value> Comma-separated list of values. To set the value format, use
FORMat:BPATtern.
Range: 0 to 4294967295
*RST: 0
Usage: Query only
BUS<m>:I2S:FRAMe<n>:LEFT:STATe?
BUS<m>:I2S:FRAMe<n>:RIGHt:STATe?
Return the status of the left and right channel of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<WordState> ERRor | OK | INSufficient
OK: the channel data is valid.
ERRor: an error occured in the channel.
INSufficient: the channel is not completely contained in the
acquisition.
Usage: Query only
BUS<m>:I2S:FRAMe<n>:TDM<o>:STATe?
Returns the state of the indicated channel of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
<o> 1..8
Selects the TDM channel.
Protocols