Rohde & Schwarz RTE Series - Page 1815

Remote control commands
R&S
®
RTE
1815User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:USB:DCONdition <SearchName>,<OperatorData>
SEARch:TRIGger:USB:DCONdition? <SearchName>
Sets the operator (equal or unequal) to set a specific payload data pattern.
Parameters:
<OperatorData> OFF | ANY | EQUal | NEQual
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:DPOPerator
<SearchName>,<DataPosOperator>
SEARch:TRIGger:USB:DPOPerator? <SearchName>
Sets the operator (any or equal) for the payload data index position.
Parameters:
<DataPosOperator> ANY | OFF | EQUal
ANY = OFF
The position of payload data is not relevant for the search condi-
tion.
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:DPOSition <SearchName>,<DataPosition>
SEARch:TRIGger:USB:DPOSition? <SearchName>
Specifies the position within a payload data packet, in which a special data pattern is to
be searched.
Parameters:
<DataPosition> Range: 0 to 1024
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:ECONdition <SearchName>,<EndpointOptor>
SEARch:TRIGger:USB:ECONdition? <SearchName>
Sets the operator to set a specific endpoint or an endpoint range. The endpoint values
are set with SEARch:TRIGger:USB:EMIN and SEARch:TRIGger:USB:EMAX.
Parameters:
<EndpointOptor> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
Protocols