Rohde & Schwarz RTE Series - Page 1816

Remote control commands
R&S
®
RTE
1816User Manual 1326.1032.02 ─ 20
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one endpoint
value to be set using SEARch:TRIGger:USB:EMIN.
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using SEARch:TRIGger:USB:EMIN and
SEARch:TRIGger:USB:EMAX.
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:EMIN
<SearchName>,<Endp>
SEARch:TRIGger:USB:EMIN? <SearchName>
Specifies an endpoint, or sets the start value of an endpoint range.
Parameters:
<Endp>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:EMAX <SearchName>,<EndpTo>
SEARch:TRIGger:USB:EMAX? <SearchName>
Sets the the end value of an endpoint range if TRIGger<m>:USB:ECONdition is set
to INRange or OORange.
Parameters:
<EndpTo>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:FCONdition <SearchName>,<FrameNoOperator>
SEARch:TRIGger:USB:FCONdition? <SearchName>
Sets the operator to set a specific frame number or a frame number range. The frame
number values are set with SEARch:TRIGger:USB:FMIN and SEARch:TRIGger:
USB:FMAX.
Parameters:
<FrameNoOperator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one frame num-
ber value to be set using SEARch:TRIGger:USB:FMIN.
Protocols