Rohde & Schwarz RTE Series - Page 1868

Remote control commands
R&S
®
RTE
1868User Manual 1326.1032.02 ─ 20
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:SWIRe:
DATA:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:SWIRe:DATA:MIN and
SEARch:TRIGger:SWIRe:DATA:MAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SWIRe:DATA:MAX
<SearchName>,<DataPatternMax>
SEARch:TRIGger:SWIRe:DATA:MAX? <SearchName>
Sets the the end value of a data type range if SEARch:TRIGger:SWIRe:DATA:
CONDition is set to INRange or OORange.
Parameters:
<DataPatternMax> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SWIRe:DATA:MIN <SearchName>,<DataPatternMin>
SEARch:TRIGger:SWIRe:DATA:MIN? <SearchName>
Specifies a data bit pattern, or sets the the start value of a pattern range.
Parameters:
<DataPatternMin>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SWIRe:ERRor:ESC <SearchName>,<ErrorESC>
SEARch:TRIGger:SWIRe:ERRor:ESC? <SearchName>
Enables triggering on an escape error.
Parameters:
<ErrorESC> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
Protocols