Measurements
R&S
®
RTE
366User Manual 1326.1032.02 ─ 20
Figure 8-9: Parameters of channel power measurement
N db down
The threshold until which the samples to the left and right of the peak value are ana-
lyzed to determine the "Bandwidth".
Remote command:
MEASurement<m>:SPECtrum:NDBDown on page 1272
Channel BW
Bandwidth over which the channel power is calculated.
Remote command:
MEASurement<m>:SPECtrum:CPOWer:BANDwidth on page 1271
Channel CF
Center frequency from which the channel power is calculated over the specified band-
width.
Remote command:
MEASurement<m>:SPECtrum:CPOWer:CFRequency on page 1271
Occup. BW
Percentage of the total power used to determine the occupied bandwidth.
Remote command:
MEASurement<m>:SPECtrum:OBANdwidth on page 1271
Threshold
Defines an absolute threshold as an additional condition for the peak search. Only
peaks that exceed the threshold are detected.
This setting is only available for spectrum waveforms. It is valid for cursor measure-
ments, spectrum measurements and peak search.
Remote command:
CURSor<m>:THReshold on page 1248
MEASurement<m>:SPECtrum:ATHReshold on page 1272
Peak excursion
Defines a relative threshold, the minimum level value by which the waveform must rise
or fall to be considered as a peak. To avoid identifying noise peaks, enter a peak
excursion value that is higher than the noise levels.
Automatic measurements
To Next Page
Loading...
