Rohde & Schwarz RTE Series - Page 414

Spectrum analysis
R&S
®
RTE
414User Manual 1326.1032.02 ─ 20
Enable math signal......................................................................................................414
Magnitude unit.............................................................................................................414
Reference level........................................................................................................... 415
Vertical scaling mode (Manual/Auto)...........................................................................415
Vertical range.............................................................................................................. 415
Range..........................................................................................................................415
Phase unit................................................................................................................... 415
Unwrap........................................................................................................................415
Suppression................................................................................................................ 416
Threshold.................................................................................................................... 416
Enable math signal
If activated, a diagram for the defined math waveform is displayed on the touch screen.
Remote command:
CALCulate:MATH<m>:STATe on page 1227
Magnitude unit
Defines the scaling of the y-axis. The display values are valid for 50Ω termination
impedance.
"Linear"
Linear scaling; displays the RMS value of the voltage.
"dBm"
Logarithmic scaling; related to 1 mW.
"dB"
Logarithmic scaling; related to reference level.
"dBμV, dBmV, dBV"
Logarithmic scaling; related to voltage 1 μV, 1 mV, 1 V, respectively
"dBps, dBns, dBμs, dBms, dBs"
Logarithmic scaling; related to time 1 ps, 1 ns, 1 μs, 1 ms, 1 s, respec-
tively.
FFT analysis