Rohde & Schwarz RTE Series - Page 597

Protocol analysis
R&S
®
RTE
597User Manual 1326.1032.02 ─ 20
If symbolic search is active, the "Frame type" is automatically set to "Data", and the
"Identifier" is shown for information.
Symbolic
Enables the symbolic search and disables all other search criteria.
Remote command:
SEARch:TRIGger:CAN:SSYMbolic on page 1527
Message
Sets the message to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:MSGValue on page 1527
Search signals
Enables the search for a specific signal value that is part of the selected message.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SSIGnals on page 1528
Signal
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
CAN and CAN FD (option R&S
RTE-K3/K9)