Rohde & Schwarz RTE Series - Page 769

Protocol analysis
R&S
®
RTE
769User Manual 1326.1032.02 ─ 20
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
Coding Standard
To define the coding of the custom serial bus to be analyzed, select one of the follow-
ing standards:
"Manchester"
Selects the coding standard Manchester.
Optional "Timing settings" are "Bit Rate" (default: disabled, 10 Mbit/s)
and "Gap time" (default: disabled, 10 µs).
See Figure 13-71.
Figure 13-72: Custom serial bus coding configuration Manchester
"Manchester II"
Selects the coding standard Manchester II, which is the inverted sig-
nal of the coding standard Manchester.
Optional "Timing settings" are "Bit Rate" (default: disabled, 10 Mbit/s)
and "Gap time" (default: disabled, 10 µs),
See Figure 13-71.
Figure 13-73: Custom serial bus coding configuration Manchester II
w
Custom: Manchester / NRZ (option R&S RTE-K50)M