Protocol analysis
R&S
®
RTE
770User Manual 1326.1032.02 ─ 20
"NRZ Clocked"
Selects the coding standard NRZ Clocked.
Optional "Timing settings" is "Gap time" (default: disabled, 10 µs), as
shown in Figure 13-74.
Figure 13-74: Custom serial bus coding configuration NRZ clocked
"NRZ
Unclocked"
Selects the coding standard NRZ unclocked.
Obligatory "Timing settings" are "Bit Rate" (default 10 Mbit/s) and
"Gap time" (default 10 µs), as shown in Figure 13-75.
Figure 13-75: Custom serial bus coding configuration NRZ Unclocked
Remote command:
BUS<m>:CMSB:CODing on page 1733
Data Source
Defines the input source for the custom serial bus data signal.
The data source for Manchester and NRZ coding standards is selected separately,
independent of each other. The data source is set to default upon switching the coding
standard.
Custom: Manchester / NRZ (option R&S
RTE-K50)M
To Next Page
Loading...
