Rohde & Schwarz SMU200A - Page 427

Instrument Function
R&S
®
SMU200A
407Operating Manual 1007.9845.32 ─ 15
Load List
Opens the file menu to select the configuration file to be edited.
SCPI command:
n.a.
New List
Calls the "Create Multi Segment Waveform List" dialog to enter the name of the new file.
A new new configuration table is created.
SCPI command:
n.a.
Define Sequencing List
Open a dialog box for configuring of the play lists (see chapter 5.8.4.2.6, "Multi Segment
Waveform Sequencing", on page 408).
SCPI command:
n.a.
Create
Creates a new multi segment waveform using the current table entries.
This multi segment waveform is saved with the file name specified in "Output File". As
with normal waveforms, the file extension is "*.wv".
Depending on the configuration of the multi segment waveform, calculation may take
some time. A panel with a progress bar and an "Abort" button appears during creating of
the multi segment waveform.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the command:
[:SOURce<hw>]:BB:ARB:WSEGment:CREate or
[:SOURce<hw>]:BB:ARB:WSEGment:CLOad.
The file name of the waveform file is always determined with the command
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:OFILe
SCPI command:
[:SOURce<hw>]:BB:ARB:WSEGment:CREate on page 617
Create and Load
Creates a new multi segment waveform using the current table entries.
This multi segment waveform is saved with the file name specified in "Output File". As
with normal waveforms, the file extension is *.wv.
Depending on the configuration of the multi segment waveform, calculation may take
some time.
Following this the "Create Multi Segment Waveform File" submenu is closed and the new
multi segment waveform is loaded.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the command:
[:SOURce<hw>]:BB:ARB:WSEGment:CREate or
[:SOURce<hw>]:BB:ARB:WSEGment:CLOad.
Baseband Signal - Baseband Block