Rohde & Schwarz SMU200A - Page 699

Remote Control Commands
R&S
®
SMU200A
679Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth <Slength>
Defines the length of the signal sequence in frames to be output in the "Single" trigger
mode (SOUR:BB:MCCW:SEQ SING).
Parameters:
1 to 10000
1
frames
<Slength>
Range:
*RST:
Default unit:
BB:MCCW:SEQ SING
sets trigger mode Single.
BB:MCCW:TRIG:SLEN 200
sets a sequence length of 200 frames. The current frame will be
output 200 times after the next trigger event.
Example:
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce <TrigSource>
Selects the trigger source.
Parameters:
INTernal|EXTernal|BEXTernal | OBASeband
INTernal
Triggering is executed by means of the Trigger command
BB:MCCW:TRIGger:EXECute or *TRG in the case of remote
control and by means of "Execute Trigger" in the case of manual
operation.
EXTernal
Triggering is executed by means of the signal on the TRIGGER 1
connector.
BEXTernal
Triggering is executed by means of the signal on the TRIGGER 2
connector.
OBASeband
(two-path instruments only)
Triggering is executed by means of the trigger signal from the
second path .
INTernal
<TrigSource>
*RST:
BB:MCCW:TRIG:SOUR EXT
executes triggering by means of the signal on the TRIGGER 1
connector.
Example:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay <Delay>
The command specifies the trigger delay for external triggering.
SOURce Subsystem