Rohde & Schwarz SMU200A - Page 830

Remote Control Commands
R&S
®
SMU200A
810Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
[SOURce[1]:]FM:STATe
State X
[SOURce[1]:]FREQuency:.... SOURce<[1]|2>
[SOURce[1]:]FREQuency:
CENTer
RF-sweep center frequency X
[SOURce[1]:]FREQuency[:
CW|FIXed]
RF frequency X
[SOURce[1]:]FREQuency[:
CW|:FIXed]:RCL
Recall RF frequency X
[SOURce[1]:]FREQuency:
MANual
Frequency for the next sweep
step
X
[SOURce[1]:]FREQuency:MODE
RF operating mode X
[SOURce[1]:]FREQuency:
OFFSet
RF-frequency offset X
[SOURce[1]:]FREQuency:SPAN
Span for the sweep X
[SOURce[1]:]FREQuency:
STARt
Start frequency for the sweep
mode
X
[SOURce[1]:]FREQuency:
STEP[:INCRement]
Step width for the frequency
setting
X
[SOURce[1]:]FREQuency:STOP
Stop frequency for the sweep
mode
X
:SOURce2:...
LF generator frequency
SOURce:LFOutput:
FREQuency
:SOURce2:FREQuency:MODE
LF operating mode X
:SOURce2:FREQuency:STARt
Start frequency for the LF
Sweep
X
:SOURce2:FREQuency:STOP
Stop frequency for the LF
sweep
X
:SOURce2:FREQuency[:
CW|FIXed]
Frequency LF signal X
[SOURce[1]:]:FSIMulator:
Fading Simulation
[SOURce[1]:]FSIMulator:
BIRThdeath:DEFault
Default Birth Death -
[SOURce[1]:]FSIMulator:
BIRThdeath:ILOSs:MODE
Insertion loss mode -
[SOURce[1]:]FSIMulator:
BIRThdeath:PATH:SPEed
Speed of moving path X
[SOURce[1]:]FSIMulator:
BIRThdeath:SPEed:UNIT
Speed unit for Birth Death -
[SOURce[1]:]FSIMulator:
BIRThdeath:STATe
Birth Death on/off X
Alphabetical List of R&S SMIQ Commands