Rohde & Schwarz SMU200A - Page 831

Remote Control Commands
R&S
®
SMU200A
811Operating Manual 1007.9845.32 ─ 15
R&S SMIQ Command Short description R&S
SMU
Remarks
[SOURce[1]:]FSIMulator:
CFACtor:EXTern
Crest factor for two channel
fading
-
[SOURce[1]:]FSIMulator:
CONFigure
Number of paths -
[SOURce[1]:]FSIMulator:
COUPle:CORRelation:
COEFficient
Coupling of correlation coeffi-
cient
-
[SOURce[1]:]FSIMulator:
COUPle:LOGNormal:CSTD
Coupling of standard deviation X
[SOURce[1]:]FSIMulator:
COUPle:LOGNormal:LCONstant
Coupling of local constant X
[SOURce[1]:]FSIMulator:
COUPle:SPEed
Coupling of speed X
[SOURce[1]:]FSIMulator:
Default
Preset fading simulation X
[SOURce[1]:]FSIMulator:
FDELay:Delay
Delay Fine Delay -
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:FDOPpler
Doppler shift Fine Delay X
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:FRATio
Ratio of doppler frequencies X
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:LOSS
Path attenuation X
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:PROFile
Fading profile X
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:SPEed
Speed X
[SOURce[1]:]FSIMulator:
FDELay:PATH<n>:STATe
path on/off X
[SOURce[1]:]FSIMulator:
FDELay:SPEed:UNIT
Speed unit Fine Delay -
[SOURce[1]:]FSIMulator:
FDELay:STANdard
Standard Fine Delay -
[SOURce[1]:]FSIMulator:
FDELay[:STATe]
Fine Delay configuration on/off X
[SOURce[1]:]FSIMulator:
IGNore:RFCHanges
Ignore frequency changes X
[SOURce[1]:]FSIMulator:
ILOSs:MODE
Insertion loss X
[SOURce[1]:]FSIMulator:
MDELay:DEFault
Default Moving Delay -
[SOURce[1]:]FSIMulator:
MDELay:MOVing:DELay:MEAN
Mean delay X
Alphabetical List of R&S SMIQ Commands