Siemens SINAMICS G120 - Page 13

Introduction to Parameters
Parameters
1-13
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
"Unit group" and "Unit selection"
For parameters where the unit can be switched, the specifications for "Unit group"
and "Unit selection" determine the group to which this parameter belongs and with
which parameter the unit can be switched over.
The standard unit of a parameter is specified in square parentheses after the val-
ues for "Min", "Max", and "Factory setting".
Min
Indicates the minimum value to which the parameter can be set.
Max
Indicates the maximum value to which the parameter can be set.
Factory setting
Indicates the default value, i.e. the value which applies if the user does not specify
a particular value for the parameter (see also "Calculated“).
Example:
Unit group: 7_1, unit selection: p0505
The parameter belongs to unit group 7_1 and the unit can be switched over using
p0505.
All the potential unit groups and possible unit selections are listed below.
Table 1-3 Unit group (p0100)
Unit group Unit selection for p0100 = Reference value
at %
012
7_4 Nm lbf ft Nm -
14_6 kW HP kW -
25_1 kgm
2
lb ft
2
kgm
2
-
27_1 kg lb kg -
28_1 Nm/A lbf ft/A Nm/A -
29_1 N/Arms lbf/Arms N/Arms -
Table 1-4 Unit group (p0505)
Unit group Unit selection for p0505 = Reference value
at %
1234
2_1 Hz % Hz % p2000
3_1 rpm % rpm % p2000
5_1 Vrms % Vrms % p2001
5_2 V % V % p2001
5_3 V % V % p2001
6_2 Arms % Arms % p2002
6_5 A % A % p2002