Siemens SINAMICS G120 - Page 742

Index
C-742
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
2512
Control word 1 (r0054), 2-545
2513
Control word 2 (r0055), 2-546
2520
Control word, speed controller, 2-547
2522
Status word, speed controller, 2-548
2526
Status word, closed-loop control, 2-549
2530
Status word, current control, 2-550
2534
Status word, monitoring functions 1,
2-551
2536
Status word, monitoring functions 2,
2-552
2537
Status word, monitoring functions 3,
2-553
2546
Control word, faults/alarms, 2-554
2548
Status word, faults/alarms 1 and 2, 2-555
2634
Sequence control - Missing enable sig-
nals, 2-556
2701
Basic braking control, 2-558
2800
Basic Functions, Parameter Manager,
2-560
2802
Basic Functions, Monitoring functions and
faults/alarms, 2-561
2804
Basic Functions, Status words, 2-562
2810
Basic Functions, STO Safe Torque Off,
2-563
2812
Basic Functions, F-DI Fail-safe Digital In-
put, 2-564
2820
SI Motion, SLS Safely-Limited Speed,
2-565
2825
SI Motion, SS1 Safe Stop 1,
Internal STOP A, B, F, 2-566
2840
SI Motion, PROFIsafe Control word and
Status word, 2-568
SI Motion, Status words, 2-567
2846
SI Motion, Parameter Manager, 2-569
2850
SI Motion, Fail-safe Digital Inputs (F-
DI0 ... F-DI2), 2-570
2855
SI Motion, Safe State selection, 2-571
3010
Fixed speed setpoints, binary selection
(p1016 = 2), 2-573
3011
Fixed speed setpoints, direct selection
(p1016 = 1), 2-574
3020
Motorized potentiometer, 2-575
3030
Main/supplementary setpoint, setpoint
scaling, jogging, 2-576
3040
Direction limitation and direction reversal,
2-577
3050
Skip frequency bands and frequency limi-
tations, 2-578
3060
Basic ramp-function generator, 2-579
3070
Extended ramp-function generator, 2-580
3080
Ramp-function generator selection, status
word, tracking, 2-581
6030
Speed setpoint, droop, 2-587
6031
Pre-control balancing, acceleration mod-
el, 2-588
6040
Speed controller, 2-589
6050
Kp_n/Tn_n adaption, 2-590
6060
Torque setpoint, 2-591
6220
Vdc_max controller and
Vdc_min controller (Vector control,
PM23
0/PM240), 2-592
6300
V/f characteristic and voltage boost,
2-583