Siemens SINAMICS G120 - Page 743

Index
C-743
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
6310
Resonance damping and
slip compensation, 2-584
6320
Vdc_max controller and
Vdc_min controller (V/f control,
PM230/PM240), 2-585
6490
Speed control configuration, 2-593
6491
Flux control configuration, 2-594
6630
Upper/lower torque limit, 2-595
6640
Current/power/torque limits, 2-596
6710
Current setpoint filter, 2-597
6714
Iq and Id controllers, 2-598
6721
Id setpoint (PEM, p0300 = 2xx), 2-599
6722
Field weakening characteristic, Id setpoint
(ASM, p0300 = 1), 2-600
6723
Field weakening controller, flux controller
(ASM, p0300 = 1), 2-601
6724
Field weakening controller
(PEM, p0300 = 2xx), 2-602
6730
Interface to the Power Module
(ASM, p0300 = 1), 2-603
6731
Interface to the Power Module
(PEM, p0300 = 2xx), 2-604
6799
Display signals, 2-605
7017
DC brake (p0300 = 1), 2-628
7200
Run-time groups / Sampling times, 2-607
7210
AND (AND function block with 4 inputs),
2-608
7212
OR (OR function block with 4 inputs),
2-609
7214
XOR (XOR function block with 4 inputs),
2-610
7216
NOT (inverter), 2-611
7220
ADD (adder with 4 inputs),
SUB (subtracter), 2-612
7222
MUL (multiplier), DIV (divider), 2-613
7224
AVA (absolute value generators), 2-614
7225
NCM (numerical comparator), 2-615
7226
PLI (scaling polyline), 2-616
7230
MFP (pulse generator), PCL (pulse short-
ener), 2-617
7232
PDE (switch-in delay), 2-618
7233
PDF (switch-out delay), 2-619
7234
PST (pulse extender), 2-620
7240
RSR (RS flipflop),
DFR(Dflipflop), 2-621
7250
BSW (binary changeover switch),
NSW (numerical changeover switch),
2-622
7260
LIM (limiter), 2-623
7262
PT1 (smoothing element), 2-624
7264
INT (integrator),
DIF (differentiating element), 2-625
7270
LVM (limit value monitor), 2-626
7950
Fixed values, binary selection
(p2216 = 2), 2-630
7951
Fixed values, direct selection (p2216 = 1),
2-631
7954
Motorized potentiometer, 2-632
7958
Closed-loop control, 2-633
8010
Spe
ed signals 1, 2-635
8011
Speed signals 2, 2-636
8012
Torque signals, motor locked/stalled,
2-637