Xerox Phaser 3610 - Page 160

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-102
050-135
Paper Jam 050-135
1. Pull out Tray4, and remove
any jammed paper.
2. If the jammed paper cannot
be removed, open the Back of
Tray to remove it.
3. Insert Tray4 and press Start.
<IOT Zone T2 + T3 + T4 + TR2 + TR3
Jam>
Cause:
When Dynamic Jam (cause) was
detected:
• 073-101 IOT Path3 SNS On Jam
When Static Jam (collateral) was
detected:
• Tray2 Path Sensor On, Tray3 Path
Sensor On, and Tray4 Path Sensor
On
FIP 1. 261
050-136
Paper Jam 050-136
1. Pull out Tray3 and Tray4, and
remove any jammed paper.
2. If the jammed paper cannot
be removed, open the Back of
Tray3 to remove it.
3. Insert Tray3 and Tray4, and
press Start.
<IOT Zone T3 + T4 + TR3 Jam>
Cause:
When Dynamic Jam (cause) was
detected:
• 072-101 IOT Path2 SNS On Jam
When Static Jam (collateral) was
detected:
•Tray3 Path Sensor On
FIP 1. 262
050-137
Paper Jam 050-137
1. Pull out Tray3, and remove
any jammed paper.
2. If the jammed paper cannot
be removed, open the Back of
Tray to remove it.
3. Insert Tray3 and press Start.
<IOT Zone T2 + T3 + TR2 + TR3 Jam>
Cause:
When Dynamic Jam (cause) was
detected:
• 072-102 IOT Option Regi On Jam
When Static Jam (collateral) was
detected:
• Tray2 Path Sensor On and Tray3
Path Sensor On
FIP 1. 263
050-138
Paper Jam 050-138
1. Pull out Tray3, and remove
any jammed paper.
2. If the jammed paper cannot
be removed, open the Back of
Tray to remove it.
3. Insert Tray3 and press Start.
<IOT Zone T3 + TR2 + TR3 Jam>
Cause:
When Dynamic Jam (cause) was
detected:
• 072-102 IOT Option Regi On Jam
When Static Jam (collateral) was
detected:
•Tray3 Path Sensor On
FIP 1. 264
Status
Code
(3615)
LCD Display Name/Description of Error FIP