R5905948 /12 Event Master Devices 129
Note: On a Gen 1 input card, in order to accommodate a 4K@60 signal, 2 or 4 connectors need to be
used.
• Connector Mapping: Shows the Unit ID, slot number, the connector number in the slot, and type of input
card.
• Auto Acquire: Enables the auto acquire mode. During acquisition, the system detects and acquires the
input type and resolution. Refer below for details regarding this feature. Default is On
Inputs auto acquire incoming video as standard. If the setting is unchecked, only the set or previously
acquired signal will be valid video.
• HDCP Mode
Enables the HDCP setting for the selected input.
The default for DisplayPort, DVI, and HDMI inputs is Off. To turn On the HDCP Mode, click on the empty
checkbox. When the checkbox displays a check mark, HDCP Mode is On. HDCP Mode is not applicable to
SDI inputs.
• EDID
All inputs (except SDI) can have an EDID (Extended Display Identification Data) set according to its
connector capacity. The currently set EDID is visible in the Current box.
• Format: The drop-down menu with its search function provide a way to select any of the available VESA or
SMPTE standard EDIDs as well as a frame rate. Once selected the Apply Button needs to be pressed in
order to program the inputs.
EM GUI orientation
To Next Page
Loading...
Need help?
General
