The NET List
Manpack Transceiver 2110 series Reference Manual 163
The new NET is created and the List Manager remains open.
1 If you want to view the NET you have created, press to close the List Manager.
Renaming a NET
When you rename a NET, references to the NET in other lists are not automatically
updated; you must go to the Address List to update any entries that refer to the NET.
For example, if the NET you renamed is used in an entry in the Address List, go to this
entry, find the reference to the old NET name, then change it so that the new name is
displayed (for help see page 183, Editing an entry in the Address List). If you do not
update the reference to the NET, the transceiver prompts you to enter an address each
time you use the entry to make a call.
Renaming a NET is a standard list function. For help see page 114, Renaming an entry in
a list.
Copying a NET
Copying a NET is a standard list function. For help see page 114, Copying an entry in a
list.
Editing a NET
Editing a NET is a standard list function. For help see page 115, Editing an entry in a
list.
Link? • select how you want member stations to operate
during link establishment
Response? • select whether or not your station responds to a
NET call
NOTE
Only stations that are members of a NET are
able to send a response.
Tune Time? • increase or decrease the tuning time
LQA Exchange? • select whether or not LQA information is
exchanged during NET calls
Slot Width? • select whether the width of the response slot is
fixed or variable
If this prompt is
displayed...
Do this...
To Next Page
Loading...
Need help?
General
