Making and receiving calls
Manpack Transceiver 2110 series Reference Manual 201
If you have the MIL-STD-188-141B ALE option installed (2110 only) and the ALE
Selective Msg entry in the Control List set to Enabled, you are able to send a message
with the start of a call if you press when prompted during the call. If you enter the
following message...
$GPS+
...the receiving station displays the current GPS information for the sending station. For
example:
89°58.041 N 138°41.234 E +0.0M 101622 (A)
NOTE
For help on entering $ see page 76, Entering special characters in
messages and names.
NOTE
The transceiver checks the length of the expanded message before
transmission. If you receive an error stating that the message is too long,
review the message and shorten the message as required.
To Next Page
Loading...
Need help?
General
