Making and receiving calls
214 Manpack Transceiver 2110 series Reference Manual
1 If LBT Mode is set to Enabled or Override allowed, you may be prompted to try
the channels again. Use the information in the following table to answer the prompt.
If you made an ANY, Group Selective, NET, or Wildcard call, you will receive
pop-up messages showing the stations from which you have received responses.
1 To complete the call, use the information in the following table.
If this prompt is
displayed...
Do this...
Chan busy:
Try again?
All|<N> chans busy:
Try again?
If Cfg LBT Mode is set to Enabled:
• press CALL to try the call again using LBT
• press to select a new channel, then press
CALL to make a call on this channel using LBT
NOTE
If only one channel was tried and found to
be occupied using LBT, you can listen for
traffic on the channel then, if clear, override
LBT by holding CALL.
If Cfg LBT Mode is set to Override allowed:
• press CALL to try the call again using LBT
• hold CALL to try the call again without LBT
(send the call regardless of any detected traffic)
• press to select a new channel, then press
CALL to make a call on this channel using LBT
• hold to select a new channel and try the call
on this channel without LBT (send the call
regardless of any detected traffic)
NOTE
To abort the call before a connection to the other station is made,
press PTT.
NOTE
If you made an ALL, ANY, Group Selective, NET, or Wildcard call,
you can send data within the established link by pressing CALL and
following the prompts.
If the link is closed automatically during these inlink messages,
consider extending the Cfg In Call Timeout entry in the Control List.
To Next Page
Loading...
