Codan 2110 series User Manual

The Control List
230 Manpack Transceiver 2110 series Reference Manual
ALE LQA Exchange Set whether or not LQA information is exchanged between
stations during each call so that the link quality can be assessed in
both directions. For more information see page 246, ALE LQA
Exchange.
On
ALE LQA Mapping Set the mapping of LQA information according to its frequency.
For more information see page 246, ALE LQA Mapping.
Frequency
ALE Retries Set the number of times the transceiver retries a channel when
attempting to establish an ALE link before trying the next best
channel in the network. For more information see page 247,
ALE Retries.
1
ALE Selective Msg
(MIL-STD-188-141B
ALE option only)
Set whether or not you can send a message with a Selective call
made in an ALE/CALM network. For more information see
page 247, ALE Selective Msg.
Enabled
ALE Silent Mode Prevent automatic ALE transmissions from the transceiver unit.
For more information see page 247, ALE Silent Mode.
Off
ALE Site Mgr Collect information on unknown ALE transceivers in the network.
If you want the transceiver to:
• only accept site information that is broadcast by other stations,
select Off
• accept, respond to, and automatically initiate requests for site
information, select Auto
• accept site information, respond to requests for site
information, and allow manually initiated Broadcast Site and
Request Site Get Status calls to other stations, select Manual
• accept site information and allow manually initiated Broadcast
Site and Request Site Get Status calls to other stations, but not
respond to requests for site information, select Restricted
For more information see page 247, ALE Site Mgr.
Off
NOTE
If ALE Silent Mode is set to On, the transceiver will not
respond automatically to requests from other stations for
site information.
ALE Soundings
(MIL-STD-188-141B
ALE option only)
Set the status of the transceiver following a sounding. For more
information see page 249, ALE Soundings.
Default
Audio Volume Set the audio volume of the transceiver. 8
Auto Resume Listen Set the scan method used when scanning is switched on by the
Auto Resume Mode entry. For more information see page 250,
Auto Resume entries.
Leave as is
Auto Resume Mode Set the action performed when the Auto Resume Time ends. For
more information see page 250, Auto Resume entries.
Start scan
Table 31: Entries in the Control List (cont.)
Name of entry Use this entry to... Default

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English