About this manual
Manpack Transceiver 2110 series Reference Manual 9
MIL-STD-188-141B
ALE
An option that enables you to make ALE ALL, ANY, Group
Selective, NET and Wildcard calls, and perform LQA reporting
and AMD messaging.
This option is available for the 2110 only.
mobile station A station that is usually mounted in a vehicle or easily
transportable. It consists of a transceiver, a power supply, an
antenna, control and accessory devices, ancillary equipment,
and appropriate connecting cables.
mode A type of reception or transmission you can use with a channel,
comprising a sideband and an IF filter.
NET call An ALE address syntax that is used to send a call from one
station to other stations that have the NET programmed in the
NET List. If these stations have their self address in the Member
Address setting they are members of this NET.
The NET address syntax may be used in Emergency, Message,
Phone, Selective, and Send Position calls if the MIL-STD-188-
141B ALE option is installed (2110 only).
network Two or more stations that use the same frequencies and call
system to communicate.
Phone call A call that enables you to connect to a public telephone network.
PTT button Press-to-talk button, located on the left side of the handset. This
button enables you to communicate during voice calls, switch
mute off temporarily, cancel voice calls prior to the point where
voice can be transmitted, cancel calls where data is being
transmitted, and exit out of editable screens without saving
changes.
revertive A signal sent by a station in response to a call.
RF filtering A device fitted to prevent noise from being generated and to
minimise the noise radiated by the wiring connected to the noise
source. These devices include filters, suppressing capacitors,
and earth straps.
transceiver unit The unit that modulates audio signals onto radio frequencies
that can be transmitted on air, and that demodulates the radio
frequencies it receives into audio signals.
scan rate See call detect time.
Selective call A call that enables you to contact a specific station then speak to
an operator.
Send Position call A call that sends your GPS position to a specific station.
You can make a Send Position call if Option GPS Enable is
installed, and your transceiver has a GPS position registered.
This term... Means...
To Next Page
Loading...
Need help?
General
