CES-128 voice encryptor option
290 Manpack Transceiver 2110 series Reference Manual
Setting up communication with the computer
To set up a transceiver to communicate with the computer:
1 Connect a standard serial cable between a COM port on the computer and the
19-way connector on the transceiver.
1 Check that:
• the RS232 Mode entry for the connector is set to CICS, and
• the RS232 Speed entry for the connector is set to 9600
1 Open a terminal-emulation program and set the following for the port connected to
the transceiver:
1 Type a simple command, for example, secure on or scan, and check that the
transceiver responds.
NOTE Use cable 08-06237-001 for the 19-way connector.
NOTE
Use a USB-to-serial-port cable to create a COM port if your
computer only has a USB port available. This cable may be ordered
from Codan (Codan part number 78-01031).
NOTE
If you need to change either of these settings, restart the transceiver to
activate the changes.
Data rate 9600 b/s
Data bits 8
Parity None
Stop bits 1
Flow control None
To Next Page
Loading...
