CES-128 voice encryptor option
Manpack Transceiver 2110 series Reference Manual 291
Programming the transceiver
To program the transceiver with a text file containing secure keys:
1 Send the file containing the secure keys as a text file to the transceiver.
The transceiver is updated dynamically. You do not have to restart the transceiver.
1 Check that the transceiver has received the secure keys by holding SEC, then
scrolling to the Select Key entry to see that the number of available Corporate secure
indexes matches the number of secure keys programmed in the text file.
1 Program any other transceivers with the same text file, as required.
1 Check that secure communication is possible between transceivers.
1 If secure communication is not possible between the transceivers, re-program the
Base secure key (secure key #0 <key>) with the key that you want to use across all
transceivers that use the CES-128 voice encryptor.
NOTE
If you have used the csstart and csstop commands, observe the
value in the checksum displayed at the terminal. The checksum must
be the same each time the same file is transferred to a transceiver.
NOTE
If the file has not been transferred correctly, reduce the data rate for
the COM port on the computer and the RS232 port on the transceiver
to 2400 b/s.
To Next Page
Loading...
Need help?
General
