Codan 2110 series User Manual

System messages
Manpack Transceiver 2110 series Reference Manual 379
Synthesiser
lock recovered
The frequency synthesiser can now lock on a frequency.
System busy The system is busy. You do not have permission to override the
current activity.
System busy
Hold to allow
The system is busy. If you want to override the current activity,
hold .
System error
<error number>
A system error has occurred. The transceiver restarts automatically.
Retry the task you were performing when the error occurred. If the
problem persists, note the system error number in the message, then
contact your Codan representative.
System locked There is a lock on the system from PTT, scan, channel or mode
change, or from a call. You do not have permission to break this lock.
System locked
Hold to unlock
There is a lock on the system from PTT, scan, channel or mode
change, or from a call. If you want to break the lock, hold .
Tcvr busy:
retry in 10 seconds
The transceiver is busy. This may be because:
• it is receiving an incoming call
• it is processing a change made to your station self address
Wait for 10 seconds, then try the task again.
Text too
long
You have entered a line of text that is too long. Reduce the length of
the text.
Too many chans
for auto ALE call
The ALE/CALM network in which you are attempting to make a call
contains more than 100 channels. The transceiver attempts to make
the call on a maximum of 100 channels.
To avoid this message and to ensure the transceiver uses all the
channels in the network, go to the Network List and reduce the
number of channels in the network to 100 or less.
Too many chans
to scan
More than 100 channels are set to be scanned. The transceiver only
scans 100 of them.
In the Network List:
• remove some channels from the channel/mode list of one or more
of the networks that are set to be scanned
• reduce the number of networks that are set to be scanned by
changing the value of the Scan Network setting in one or more
networks to Don’t scan
Tune aborted Automatic tuning of the antenna was aborted because you pressed
PTT during an automatic tuning cycle.
Tune antenna
then retry call
Your call cannot be made until the antenna is tuned. Tune the antenna
then try the call again.
Tune failed The transceiver could not automatically tune the antenna.
Table 53: System messages (cont.)
Message Description

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English