Operating the transceiver
Manpack Transceiver 2110 series Reference Manual 81
Setting your station self address
To set your station self address:
1 Hold to open Quick Start.
1 Scroll to Set my address, then press .
1 Enter your station self address (up to 10 digits for a Codan Selcall network and up to
15 upper-case/numeric characters for an ALE/CALM network), then press .
1 Press to close Quick Start, if required.
Adding/Editing an entry in the Address List or Call Book
To add or edit an address that you call frequently:
1 Hold to open Quick Start.
1 Scroll to Address/CallBk, then press .
1 Enter the name of the station or person you want to add to the list, or use or to
scroll to an existing entry, then press .
1 Scroll to the type of call you want to make, enter the station address you want to call,
then press .
1 If you selected Message? or No call type, enter the message, then press .
If you do not want to enter a message, press .
1 Scroll to the call system you want to use to make the call, then press .
1 If you selected Phone? or No call type, scroll to <blank> as the phone link you
want to use, then press .
When all the changes have been made to the call address, the transceiver returns to
Quick Start.
1 If you want to add more call addresses to your Address List or Call Book, scroll to
Address/CallBk, then repeat this process.
1 Press to close Quick Start, if required.
NOTE
When Quick Start is available, any self address that you enter using this
method replaces the previous self address. If you want to enter more than
one self address, and hence disable the Quick Start features, see page 92,
Entering your station self address.
CAUTION
If you intend to send calls to a station that is compatible with 4-digit
self addresses only, you must set up a 4-digit self address.
NOTE For help with entering text see page 72, Entering and editing text.
NOTE For help with entering text see page 72, Entering and editing text.
To Next Page
Loading...
Need help?
General
