Covidien WarmTouch - 9.3 Separating the Front and Rear Enclosures

Accessing the Inside of the Warming Unit
9-2 Service Manual
9.3 Separating the Front and Rear Enclosures
Figure9-1.Separated Enclosures
Requirements:
• Torque driver with #2 Phillips bit
 WARNING:
Disconnect the warming unit's power cord from the AC power source before
performing this procedure.
To separate the front and rear enclosures:
1. If the power cord is secured around the back of the unit, unwind it completely.
2. Position the warming unit on its front so the bottom of the unit is accessible
(Figure 9-2).