Packing for Shipment
14-2 Service Manual
14.3 Packing in the Original Carton
If packing the warming unit in its original shipping carton, use the following
procedure and reference Figure 14-1 on page 14-3.
To pack the warming unit in its original carton:
1. Place the lower insert on the work surface.
2. Place the die-cut tray over the lower insert with the flat side up. Make sure that
the lower insert is centered under the die-cut opening of the tray.
3. Place the die-cut pad on top of the tray, aligning the cutouts.
4. Place tape on all four sides and in the center of the curved part of the cutout.
5. Place the two corrugated nozzle support pieces into the notch at the bottom of
the nozzle hook. Place the nozzle on the hook.
6. Place the warming unit into a poly bag.
7. Place the unit, front side up, into the tray.
8. Place the upper insert over the front of the unit.
9. Place the scope pad into the upper insert. Align the folded flaps of the scope pad
with the edges of the upper insert. Place any items to be shipped with the
warming unit (such as the power cord and shipping documents) into the scope
pad.
10. Place the shipping carton on the work surface with the opening toward the tray.
11. Slide the tray into the carton.
12. Set the carton upright and close the carton lid. Seal the carton with packing tape.
13. Label the carton with the shipping address, return address, and RGA number.
To Next Page
Loading...
