Covidien WarmTouch - 13.7 Electromagnetic Compatibility (EMC)

Product Specifications
13-4 Service Manual
13.7 Electromagnetic Compatibility (EMC)
13.7.1 Manufacturer’s Declaration
The warming system is suitable for prescription use only in the specified elec-
tromagnetic environments. Use the warming system in accordance with the
electromagnetic environments described in the following sections.
13.7.2 Electromagnetic Emissions
 Caution:
The warming system is not intended for use in residential environments and
may not provide adequate protection to radio communication services in such
environments.
Table13-1.Electromagnetic Emissions Guidelines
Guidance and Manufacturer’s Declaration—Electromagnetic Emissions
(IEC/EN 60601-1-2:2007, Table 1)
The warming system is intended for use in the electromagnetic environment specified below. The cus-
tomer or the user of the warming system should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment Guidance
RF emission
CISPR 11
Group 1,
Class A
This is a class A product per IEC CISPR 11 and is not
intended to be used in a residential environment. If
used in a domestic environment, this equipment may
not offer adequate protection to radio-frequency
communication services. The user may be required to
take mitigation measures, such as relocating or re-ori-
enting the equipment.
Harmonic emissions
IEC/EN 61000-3-2
Class A The warming system is suitable for use in all establish-
ments other than domestic and those directly connect-
ed to the public low-voltage power supply network
that supplies buildings used for domestic purposes.Voltage fluctuation/
flicker emissions
IEC/EN 61000-3-3
Complies